ARADUR® 370

In combination with liquid epoxy resins and suitable fillers for tough and hard mortars or mastics. In formulations with a high binder content a degree of residual tackiness may remain, and smearing may occur, particularly at low working temperatures. Under these conditions we recommend the proportional use of rapid hardeners such as Aradur 10, 14 and 16. Compared with Aradur 250, Aradur 370 features a distinctly lower degree of viscosity and is accordingly easier to work.

Mainly with liquid epoxy resins such as ARADUR® GY 250, GY 783, GY 784 for cold-curing, solvent-free mastics or epoxy resin mortars. Also for formulation as a reaction adhesive on steel or mineral substrates.

The optimum mix ratio for Araldite GY 250 and Aradur 370 is 100:50 parts by weight.

Mandatory and recommended industrial hygiene procedures should be followed whenever our products are being handled and processed.

ARADUR® 370 should be stored in a dry place, preferably in the sealed original container, at temperatures between 2 and 40 °C. The product should not be stored exposed to direct sunlight. Hardener ARADUR® 370 can vary within a certain colour range. This range is specified according the Gardner colour scheme from yellowish to brownish appearance. Additionally it can happen that the harddner shows a greenish appearance. This effect can be observed once a while, but does not influence the good technical properties of the product.