ARATHANE® 5814 IS / ARATHANE® 5814 PO

• No TDI or MOCA®
• High thermal conductivity
• Excellent insulation properties
• Flame retardance, UL® Recognized by UL 94 V-0 at 6mm
• Good UV stability
• Good thermal endurance

Recommended cure time at 25°C,  24* hours

* Cure schedule results in approximately 90% of final properties. Additional room temperature or elevated temperature curing is required for 100% properties.

• Mix using meter-mix dispensing equipment, or manually, as follows :
• Weigh the desired amount of hardener into mixing container with resin.
• Mix thoroughly by means of mechanical mixer or manual stirring.
• Be sure to scrape the side and walls of the mixing container during mixing.
• Check for uniform color as a sign or complete mixing.
• Vacuum deairing is recommended to remove any entrapped air from the mixing procedure.
• To deair most products, 1-2 minutes under full vacuum is recommended for each quart of volume of mixed material.
• Quickly dispense potting material into cavity or channel to be sealed; be certain not to trap air bubbles as viscosity builds.
• To reduce the cure time, the casting is often allowed to gel at room temperature and then post-cured 2-6 hours at 60-80°C.
• Small castings can be processed and directly cured at slightly higher temperatures (40-90°C)

keep out of reach of children

• ARATHANE® 5814 / ARATHANE® 5814 should be stored in a dry place, in the sealed original container, at temperatures between +18°C and +40°C (+64.4°F and 104°F) for Arathane® 5814 IS and between +2°C and +40°C (+35.6°F and 104°F) for Arathane® 5814 PO. Under these storage conditions, the shelf life is 1 year.
• The product should not be exposed to direct sunlight.
• If crust has formed, product is no longer usable.
• This product is moisture-sensitive and packaged under a blanket of dry nitrogen.